Lenovo d20 4158 Manual Do Equipamento
6.
Install the new hard disk drive fan assembly bracket into the chassis by
aligning the four latches 1 on the bracket with the corresponding holes in the
chassis and pushing the bracket inward until it snaps into position.
aligning the four latches 1 on the bracket with the corresponding holes in the
chassis and pushing the bracket inward until it snaps into position.
7.
Replacing an optical drive
Attention
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” in the ThinkStation Safety and Warranty Guide that came
with your computer. To obtain a copy of the ThinkStation Safety and Warranty Guide, go to:
http://www.lenovo.com/support
“Important safety information” in the ThinkStation Safety and Warranty Guide that came
with your computer. To obtain a copy of the ThinkStation Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace an optical drive.
To remove or replace the optical drive, do the following:
1.
1.
Remove the computer cover. See “Removing the cover” on page 96.
2.
Remove the front bezel. See “Removing the front bezel” on page 99.
3.
Locate the optical drive. See “Locations” on page 97.
4.
Note the location of the optical drive cables. Disconnect the signal and power
cables from the rear of the optical drive.
cables from the rear of the optical drive.
Chapter 10. Replacing FRUs - Menorca Computers
123