NEC px-33m3a Manual Do Utilizador

1. Plug in the power cord to an electrical outlet to connect power.

2. Press POWER to turn the monitor on.

3. Press POWER again to turn the monitor off.

Press the POWER OFF key on the remote control unit to turn the monitor

off when the monitor is turned on.

The monitor will go into the standby condition and the STANDBY/POWER

indicator will light up orange.

Press the POWER ON key on the remote control unit to turn the monitor on

when the monitor is in the standby condition. The STANDBY/POWER indi-

cator will light up green.

Press the desired input selection key (VIDEO 1 or VIDEO 2) on the remote

control unit or the monitor.

NOTE: During VIDEO input, set the 75

Ω

/HIGH switch to “75

Ω

” if VIDEO

THROUGH OUT is not being used.

1)To adjust:

Adjust the contrast of video display.

Adjust the brightness of video display.

Adjust the color intensity of video display.

Adjust red and green values of video display.

Adjust picture detail of video display.

2) Adjust the picture position.

To reset the stored adjustment data and recall the factory preset data:

Press the NORMAL keys.

Proceed as follows for correct setting of the monitor when input is via mini D-

SUB 15 Pin (ANALOG) terminal.

Connect IBM PC or Macintosh to the mini D-SUB 15 Pin terminal, and press

RGB 1.

When using with a .

1. Connect the R, G, B, H/CS and V terminals on the terminal board to the

outputs of your RGB equipment.

2. Set all of the 75

Ω

/HIGH Impedance select switches to “75

Ω

”.

3. Press the RGB 2 key.