U-Line ADA24R Guia Do Utilizador

Reposition the shelves as follows:

1. Remove shelf retention clip.

2. Pull shelf out about 6" (Figure 10, 1), until back of 

shelf clears the “hump” on the right-hand side.

3. Tilt up right-hand edge of shelf (Figure 10, 2).

4. Remove shelf from unit by pulling out (Figure 10, 3).

Insert the shelves as follows:

1. To move to a different position in the unit, insert shelf 

at an angle, approximately 15-20°, over the rib in the 
side of the unit where you want to place the shelf. The 
shelf must be started into the unit at an angle to clear 
the door.

2. Continue to slide the shelf into the unit at an angle 

until it clears the door.

3. Lower the shelf and push it in completely.

4. Install shelf retention clip.

To replace the light bulb in your U-Line unit:

1. Grasp the edges of the light housing lens 

(Figure 11, 1) opposite the exposed tab, and gently 
push the lens towards the tab (Figure 11, 2).

2. Pull the edge of the lens down (Figure 11, 1), and 

swing it out of the light housing.

3. Replace the bulb only with a genuine U-Line P/N 31317 

replacement.

4. Replace the lens by first inserting the tab side back into 

the housing at a slight angle. While gently pushing the 
lens towards the tab end, push the free end up into the 
housing, and release when you will hear a snap/click.

ULIN_0001_A