Cyberhome dvr 1200mu Guia De Utilização

You can enjoy high quality picture reproduction by 
using the component video output instead of S-Video 
or Composite video output. Connect the cables 
according to the illustration.

Change the Setup Menu - 
Audio/Video - Scan Mode to P-SCAN 
if your TV supports Progressive Scan 
or Interlace if it supports component.  
See Pages 20 - 25 for general setup 
instructions, Page 22 for Scan Mode 
information.

S-VIDEO is a higher quality connection than standard composite video, and requires a special S-Video cable (not 
included). The S-Video connector is distinguishable by its 4 pins, as shown below. If your TV has an S-Video input, 
it's recommended that you use this type of connection for better picture quality. 

First, obtain a special S-Video cable. Connect the 
S-Video output from the unit to the corresponding 
input on your TV. 

On your TV, select the S-Video input. This is 
normally done by selecting "Video 2" or "AV2" with 
the remote control. On some TVs, this is done by 
using the channel selector. Refer to your TV manual 
for details.

On your TV, select the component or 
progressive scan input. This is 
normally done by selecting "Video 2" 
or "AV2" with the remote control. On 
some TVs, this is done by using the 
channel selector.  Refer to your TV 
manual for details.

S-Video & Component Video Connections

COMPONENT VIDEO CABLE
        ( NOT INCLUDED )

 S-VIDEO CABLE
( NOT INCLUDED )