Cyberhome dvr 1200mu Guia De Utilização

! The AC Power cord may be loose or not plugged in. Make sure the power cord is 

secure in the AC socket and the connector on the back of the player.

! The unit may be in Standby Mode. Turn the player on with the remote POWER 

button, or if you are using a power strip, make sure the switch is switched ON.

! There must be a pause between powering the unit down and back on of a few 

seconds.

! The disc may be dirty. Try cleaning the disc.
! Make sure the disc is not in upside-down
! The REGION CODE of the disc may not match that of the player. In this case, the 

disc cannot be used.

! Make sure you're aiming the remote directly at the player's remote sensor, located in 

the front display. 

! Make sure there are no obstacles between the remote and the player. 
! The batteries may be drained. Try changing the batteries in the remote. 
! You could be using the remote too far away. Try within 4 meters of the player.

! Make sure the connections from the player to the TV are secure.
! Verify that the TV's channel is set to match the video input you're using. Refer to the 

TV's documentation. On most TVs the "Aux In", "Video In" or "A/V In" channel should 
match the video input connector.

! If you're using the S-Video connector, the TV may have a separate input channel for 

this type.

! The Video Aspect Ratio may be set wrong for your Television type.  
! Enter the SETUP MENU and select the A/V OUTPUT 4 VIDEO menu. Try changing 

the TV SHAPE setting to 4:3 PanScan (Pan & Scan) if you are using a standard TV, 
or 16:9 Wide if your TV is a widescreen type. 

Common Problems and Solutions

! The Video Input Source may be protected with MacroVision Copy Protection. 
! The disc may already contain recordings of a different TV System type - PAL or 

NTSC. If the disc already contains a PAL recording, you cannot record from an NTSC 
source, and vice versa. 

! The maximum number of titles or chapters may have been reached. 
! If the disc is a DVD+R, it may already be FINALIZED.

! The disc is not a DVD+RW disc.
! The disc may be dirty. Try cleaning the disc.

! If the disc is a DVD+R, make sure it has been FINALIZED. 
! The DVD Player may not support DVD+R/RW discs.

! The Time/Date is invalid or conflicts with another schedule.
! The Time/Date settings of the Recorder are incorrect. Set the Time/Date in SETUP.
! The specified Video Input Source is unavailable. 
! The disc is out of space. 

! If the player is in Standby Mode with the glowing LED to the left of the disc tray, the 

disc will not eject. Turn the player on with the Remote Control and then eject the 
disc. 

! This DVD Recorder is built with Macrovision copy-protection. This will distort the 

signal when used with VCRs. Connect the player directly to the TV. Some VCR/TV 
combos may be incompatible with DVD players.