ATTO Technology diamond array s Manual Do Utilizador
27
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
5.4.1 ExpressNAV Pages
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on a specific topics. Each page can be reached through the menu on the left hand side of each
page.
based on a specific topics. Each page can be reached through the menu on the left hand side of each
page.
Status
Contains general array information.
• Unit Information including Vendor ID, Product
ID, Firmware Revision and Serial Number
• Environmental
Information
• World Wide Identifiers including Node Names
and Port Names
• Host Interface Card Status
• Fan
• Fan
Status
• Power Supply Status
• Storage Status including ATA Disk Errors and
• Storage Status including ATA Disk Errors and
Logical Unit Conflicts
Ethernet
Configures the Ethernet port.
• IP
Address
• IP
Gateway
• IP Subnet Mask
• Ethernet
• Ethernet
Speed
• Use
DHCP
Refer to
on page 23 and
Ethernet Commands
on page 35 for
details.
SNMP
Remote system monitoring is available using
Simple Network Management Protocol (SNMP).
Simple Network Management Protocol (SNMP).
• Updates
• Traps
• Trap Recipient IP Addresses
• Traps
• Trap Recipient IP Addresses
Refer to
Ethernet Commands
on page 35 and
details on each parameter.
Serial Port
Contains the necessary information to configure
the serial port including baud rate and echo.
the serial port including baud rate and echo.
Refer to
on page 21 and
on page 39 for more
information on each parameter.
Fibre Channel
Contains parameters and information to manage
the Fibre Channel port.
the Fibre Channel port.
• Data
rate
• Full
duplex
mode
• Connection
mode
Refer to
Connecting a Fibre Channel Array
on page 11
37 for more information.
Storage Management
Shows information about the drives and their
status. Information includes
status. Information includes
• Sled
Number
• Capacity of each sled
• Number
• Number
of
errors
• Configuration type (JBOD, RAID5, etc.)
• Virtual
• Virtual
ID
You may place sleds on or off line by selecting or
de-selecting a check box.
de-selecting a check box.
Refer to
page 15 and
45 for more information.
Once you open this page, several other
configuration pages are available on the menu on
the left hand side of the page.
configuration pages are available on the menu on
the left hand side of the page.
RAID
Contains the necessary information and
parameters to configure RAID groups.
Information provided includes
parameters to configure RAID groups.
Information provided includes
• Type of configuration (RAID5, JBOD, etc.)
• Virtual Disk ID
• State
of
sleds
• Capacity of sleds
• Interleave
values
You may change the configuration of these
parameters
parameters
• Configuration Type (JBOD, RAID5)
• Number of Groups (when applicable)
• Interleave
• Striping method (sled or drive)
• Number of Groups (when applicable)
• Interleave
• Striping method (sled or drive)
• Rebuild
priority