Manualsbrain.com
  1. Manuais
  2. Marcas
  3. ATTO Technology
  4. diamond array s
  5. Manual Do Utilizador

ATTO Technology diamond array s Manual Do Utilizador

Download
Página de 105
85
 
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
 10.2  Resetting Defaults
Resetting the Diamond Storage Array to defaults will not alter the RAID configuration, IP configuration 
or Telnet information. However, resetting the Diamond Storage Array to factory defaults is a last-ditch 
effort to recover from corrupt configurations or complete failure. All data will be lost. 
Default
If you need to return to the default settings of the 
Diamond Storage Array but do not want to lose 
data or Ethernet settings, use the CLI command 
RestoreConfiguration default 
in the CLI or in the 
Advanced CLI Configuration page in the 
ExpressNAV interface.
To return to Default settings
1
Connect to Diamond Storage Array services via 
the RS-232 port or the optional Ethernet 
management services card (refer to 
on page 17). You should now be in 
Command Line Interface.
2
Continue with the CLI or access the Advanced 
CLI page of the ExpressNAV interface (refer to 
ATTO ExpressNAV: Browser-based Interface 
on 
page 25). 
Note
Because the ExpressNAV pages take you 
through this process easily, the following 
instructions are based on the CLI commands. 
Use these instructions as a guide in 
ExpressNAV.
3
Type RestoreConfiguration default to reset 
the system configuration (See Exhibit 10.2-1 
for a list of configurations which will be 
changed).
4
Type FirmwareRestart
 
or cycle power of the 
Diamond Storage Array.
5
Reboot the host PC after the Diamond Storage 
Array completes its power on cycle.
Factory Default
Resetting the Diamond Storage Array to factory 
defaults is a last-ditch effort to recover from 
corrupt configurations or complete failure. All 
data will be lost.
CAUTION
CAUTION
Data will be lost if you follow these 
procedures. Make sure you have no other 
choice before resetting the Diamond 
Storage Array to factory defaults.
To reset to factory defaults
firmware version 2.5.3 or higher
1
Connect to Diamond Storage Array services via 
the RS-232 port or the optional Ethernet 
management services card (refer to 
on page 17). You should now be in 
Command Line Interface.
2
Continue with the CLI or access the Advanced 
CLI Configuration page of the ExpressNAV 
interface (refer to 
ATTO ExpressNAV: Browser-
based Interface 
on page 25). 
Note
Because the ExpressNAV pages take you 
through this process easily, the following 
instructions are based on the CLI commands. 
Use these instructions as a guide in 
ExpressNAV.
3
Type RestoreConfiguration factorydefault to 
reset the system configuration. (See 
Exhibit 10.2-1 for a list of configurations which 
will be changed).
4
Type FirmwareRestart or cycle power.
5
Reboot the host PC after the Diamond Storage 
Array completes its power on cycle.