EchoStar dvr-5000 hdd Manual Suplementar
Section 3
Page 3 - 4
EchoNAV 2.2
© 2
0
0
02 E
choS
tar
Inte
tar
Inte
rnati
onal
C
C
o
rp
orat
io
n
A
ll ri
gh
ts
re
se
se
rv
ed
26. On the RCU:
a. press thekey to set the EL (East limit);
b. at the Motor error, press thekey once;
c. press the OK key.
b. at the Motor error, press thekey once;
c. press the OK key.
27. On the RCU, press the OK key.
28. Select the most East SAT which you can receive.
29. If you want to add your own defined East SAT,
29. If you want to add your own defined East SAT,
select S00 (Goes to the menu where you can
define your own satellite, for detailed information,
refer to section 6). If not proceed with step 31.
define your own satellite, for detailed information,
refer to section 6). If not proceed with step 31.
30. If you want to add your own defined transponder
for the selected satellite, go to the TP field and
select TP00 (Goes to the menu where you can
define your own transponder, for detailed
information, refer to section 6). If not proceed with
step 31.
select TP00 (Goes to the menu where you can
define your own transponder, for detailed
information, refer to section 6). If not proceed with
step 31.
31. When in the Position field:
a. press and hold thekey and watch the signal
indicator for an indication;
b. in the signal indicator, make sure a network
name is shown;
c. press thekey to select another transponder for
signal verification;
d. press thekey to select the Position field;
e. use thekey to fine tune for the best signal
e. use thekey to fine tune for the best signal
level and quality;
f. press the OK key, note that the saved position of
the satellite is shown.
32. Repeat the procedure for the middle and most
West SAT.
33. Set the WL (key), refer to step 26.
34. Go to the SAT list field.
35. On the RCU, press the OK key to advance.
34. Go to the SAT list field.
35. On the RCU, press the OK key to advance.