Yamaha AVX-S80 Manual Do Proprietário

If you want to increase the power output to the speakers,
or want to use another amplifier, connect an external
amplifier to the 6CH PREOUT jacks as follows.

• When you have connected this system to an external amplifier,

select PRE or BOTH in “9 SP/PRE OUT” on the SET MENU.
(See page 39.)

Front channel line output jacks.

Rear channel line output jacks.

Center channel line output jack.

Low bass signals distributed from the front, center and/or
rear channels are directed to this jack if they are assigned
to this jack. (The cut-off frequency of this jack is 90 Hz.)
The LFE (low-frequency effect) signals generated when
Dolby Digital or DTS is decoded are also directed if they
are assigned to this jack.

y

• The adjustments made in the following settings have an effect

on the signals output from the 6CH PREOUT jacks.
– BASS BOOST settings
– Speaker settings
– DSP programs

Plug in this system to the wall outlet.

■

The memory back-up circuit prevents the stored data from
being lost when the power cord is disconnected from the
AC outlet, or the power supply is temporarily cut due to
power failure. However, if the system is turned off for
more than one week, the stored setting will be cleared. If
so, set the setting again.
• Volume level
• Input source
• Speaker output level (center, rear L/R and subwoofer)
• Sleep timer
• Parameter
• Delay time
• Set menu
• Preset station

When all connections are complete, turn on the power of
this system.

1

2

• When you use only some of the included 6 speakers or when

using commercially available speakers, adjust speaker mode
settings soon after turning the power on. See “1 SPEAKER
SET (speaker mode settings)” on page 36 for details.

E3-S80-8-18(6.29)a

02.6.29, 4:32 AM

17