Yamaha gx-5 Manual Do Proprietário

•

When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.

•

The automatic recording level control circuit automatically
controls the level of the input signal used for recording.

•

Adjusting the VOLUME control and using the built-in
sound field processor have no effect on the recorded
sound.
If, however, the built-in graphic equalizer is used, its effect
is recorded along with the source.
* Music with an equalizer effect is suitable for listening to

inside a car etc.

•

For the tape deck, the deck which can be used for
recording is the DECK B only. When recording, be sure to
load a tape into the DECK B cassette compartment.

Press the TUNER input selector button.

Tune to the desired station. (Refer to the “TUNING
OPERATION” on page 17 and 18.)

Load a tape into the DECK B cassette compartment.

When recording with the Dolby NR system, select the
Dolby NR B or C position by pressing the DOLBY NR
button. If not, set it off.
*

For selection of the Dolby B or C position, refer to the 
“Dolby B and C Type Noise Reduction” on page 23.

Select the reverse mode “

” to record on only one

side, or “

” for continuous recording on both sides by

pressing the reverse MODE selector button.

Press the REC/PAUSE button.
*

The indicator over the button will light up and the play
direction indicators will flash.

Press the play 

button to record on side A, or the play

button to record on side B.

*

For continuous recording on both sides, begin on side
A. Recording stops automatically at the end of side B.

Press the REC/PAUSE button.

To resume recording, press the play button whose
indicator is flashing.

Press the stop 

button.