Yamaha HTR-6040 Guia Do Utilizador

Página de 93
19 
En
Connections
English
PRE
P
ARA
T
ION
Both FM and AM indoor antennas are supplied with this 
unit. In general, these antennas should provide sufficient 
signal strength. Connect each antenna correctly to the 
designated terminals.
• The AM loop antenna should be placed away from this unit.
• A properly installed outdoor antenna provides clearer reception 
than an indoor one. If you experience poor reception quality, 
install an outdoor antenna. Consult the nearest authorized 
Yamaha
 dealer or service center about outdoor antennas.
• The AM loop antenna should always be connected, even if an 
outdoor AM antenna is connected to this unit.
Once all connections are complete, plug the power cable 
into the AC wall outlet.
■ AC OUTLET(S) (SWITCHED)
Australia model ...................................................... 1 outlet
Korea model ............................................................... None
Other models ......................................................... 2 outlets
Use these outlet(s) to supply power to any connected 
components. Connect the power cable of your other 
components to these outlet(s). Power to these outlet(s) is 
supplied when this unit is turned on. However, power to 
these outlet(s) is cut off when this unit is set to the standby 
mode. For information on the maximum power or the total 
power consumption of the components that can be 
connected to these outlet(s), see “Specifications” on 
page 74.
■ Turning on this unit
Press 1
STANDBY/ON (or HPOWER) to turn 
on this unit.
y
When you turn on this unit, there will be a 4 to 5-second delay 
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press 1
STANDBY/ON (or GSTANDBY) to set 
this unit to the standby mode.
In the standby mode, this unit consumes a small amount of 
power in order to receive infrared signals from the remote 
control.
Connecting the FM and AM 
antennas
Notes
ANTENNA
AM
GND
FM
UNBAL.
75
MD/
CD-R
IN 
(PLAY)
AM loop 
antenna 
(supplied)
Ground
For maximum safety and minimum 
interference, connect the antenna GND 
terminal to a good earth ground. A good 
earth ground is a metal stake driven into 
moist earth.
Indoor FM 
antenna 
(supplied)
Outdoor AM antenna
Use a 5 to 10 m (16 to 32 ft) of 
vinyl-covered wire extended 
outdoors from a window.
Connecting the power cable
Turning on and off the power
AC OUTLETS
(U.S.A. model)
Power cable