Yamaha RX-SL80 Manual Do Proprietário

Do not connect this unit or other components to the mains 
power until all connections between components are 
complete.
• Make sure that all connections are made correctly - that 

is to say, L (left) to L, R (right) to R, “+” to “+” and  
“–” to “–”. Some components require different 
connection methods and have different jack names. 
Refer to the operating instructions for each component 
you wish to connect to this unit.

• After you have completed all connections, check them 

again to make sure they are correct.

• The jack names correspond to the names on the input 

selector.

■

■

You can input analog signals from audio components by 
connecting audio pin cable to the analog jacks on this unit. 
Connect red plugs to the right jacks and white plugs to the 
left jacks.

■

This unit has digital jacks for direct transmission of digital 
signals through either coaxial or fiber optic cables. You 
can use the digital jacks to input PCM, Dolby Digital and 
DTS bitstreams. All digital input jacks are compatible 
with 96-kHz sampling digital signals.

• This unit handles digital and analog signals independently. Thus 

audio signals input to the digital (OPTICAL or COAXIAL) 
jacks are not output to the analog VCR OUT (REC) jacks.

• The OPTICAL jacks on this unit conform to the EIA standard. 

If you use a fiber optic cable that does not conform to this 
standard, this unit may not function properly.

Pull out the cap from the optical jack before you connect 
the fiber optic cable. Do not discard the cap. When you are 
not using the optical jack, be sure to put the cap back in 
place. This cap protects the jack from dust.

S

V

O

V

V

V

L

R

C

video signal direction

left analog cables

right analog cables

optical cables

coaxial cables

video cables

audio signal direction