Yamaha RX-V2500 Manual Do Proprietário

Página de 112
58
SYSTEM OPTIONS
Use this menu to set up basic system parameters.
1
Set AMP/SOURCE/TV to AMP.
2
Press TOP on the remote control.
3
Select Manual Setup, then press 
 h
.
4
Select Basic, then press 
 h
.
5
Select the desired parameters, then press 
 h
 
to access and adjust.
• Most of the parameters described in the basic menu are set 
automatically when you run auto setup. You can use the basic 
menu to make further adjustments, but we recommend running 
auto setup first.
• You can reset these parameters by performing the auto setup 
procedure (see page 26).
Test Tone (Test tone)
Turns the test tone output on or off for Speaker Set, 
Speaker Distance and Speaker Level settings.
Manual Setup > Basic > Test Tone >
Choices: 
Off
, On
y
• If you use a handheld SPL meter, hold at arms length and point 
upwards so that the meter is in the listening position. With the 
meter set to the 70 dB scale and to C SLOW, calibrate each 
speaker to 75 dB.
• This menu item is also available in the front panel display 
system options menu (see page 82).
Loud test tones will be output when “On” is selected. In this case, 
make sure no children are present in the listening room.
Speaker Set (Speaker set)
Use to manually adjust any speaker setting.
Manual Setup > Basic > Speaker Set >
y
If you are not satisfied with the bass sounds from your speakers, 
you can change these settings according to your preference.
Set any THX speakers to Small.
Front (Front speakers)
Choices: Large, 
Small
• Select “Large” if you have large front speakers. The 
unit directs the entire range of the front left and right 
channel signals to the front left and right speakers.
• Select “Small” if you have small front speakers. The 
unit directs the low-frequency signals of the front 
channel to the speakers selected with Bass Out.
Center (Center speaker)
Choices: Large, 
Small
, None
• Select “Large” if you have a large center speaker. The 
unit directs the entire range of the center channel signal 
to the center speaker.
• Select “Small” if you have a small center speaker. The 
unit directs the low-frequency signals of the center 
channel to the speakers selected with Bass Out.
• Select “None” if you do not have a center speaker. The 
unit directs all of the center channel signal to the front 
left and right speakers.
Manual setup: Basic
Note
AMP
SOURCE
TV
Test Tone
Speaker Distance
Speaker Level
Speaker Set
Sound
Basic
Option
Off
On
Speaker Set
Speaker Distance 
Test Tone
Note
Large
Small
Center
Surround
Front
Large
Small
None
Surround
Surround Back
Center
Front
00_RX-V2500U_EN.book  Page 58  Friday, August 20, 2004  5:20 PM