Yamaha RX-V4600 Manual Do Proprietário

This menu adjusts the optional system settings.

Select Manual Setup, then press h.

Select Option then press h.

Select the desired parameters, then press h 
to access and adjust.

■ Display (Display)

Use this feature to adjust the GUI and front panel displays.
Manual Setup > Option > Display >
Choices: Dimmer, Video Conv., Short Message, Position, 

Wall Paper

Dimmer (Dimmer)
Use to adjust the brightness of the front panel display.
Choices: –4 to 0

Video Conv. (Video conversion)
Use this feature to turn on/off conversion of composite 
(VIDEO) signals to both S-video and component signals. 
This allows you to output converted video signals at 
the S VIDEO or COMPONENT VIDEO jacks when no 
S-video or component signals are input. This feature also 
converts S-video signals to component signals when no 
component signals are input.
Choices: Off, On
• Select “Off” not to convert any signals. 
• Select “On” to convert composite signals to S-video 

and component signals, and to convert S-video signals 
to component signals.

y

When using the THX system, we recommend setting Video Conv. 
to “Off”.

• Converted video signals are only output at the MONITOR OUT 

jacks. When recording you must make the same type of video 
connections (composite or S-video) between each component.

• When converting composite video or S-video signals from a 

VCR to component video signals, the picture quality may suffer 
depending on your VCR.

Short Message (Short message)
Use this feature to turn on/off the short message display.
Choices: Off, On
• Select “Off” to turn off the short message display. 
• Select “On” to turn on the short message display.

• The short message display may not display properly depending 

on the type of input signal and video monitor used.

• If Video Conv. is set to “Off”, the short message display is not 

displayed even if “On” is selected.

Position (Position)
Use to adjust the vertical and horizontal position of the 
GUI display.
Choices: –5 (downward/left) to +5 (upward/right)
• Press k to raise the position of the GUI display.
• Press n to lower the position of the GUI display.
• Press h to shift the position of the GUI display to the 

right.

• Press l to shift the position of the GUI display to the left. 

Wall Paper (Wallpaper)
Use this feature to select the background when no image is 
input from an external source. If you do not want to 
display the background, select None.
Choices: None, Yes, Gray

If Video Conv. is set to “Off”, no background is displayed even if 
“Yes” is selected.

y

This menu item is also available in the front panel display system 
options menu (see page 90).