Yamaha RX-Z9 Guia Do Utilizador
28
CONNECTIONS
Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
■
Connecting the AM loop antenna
1
Set up the AM loop antenna, then connect it
to the terminals on this unit.
to the terminals on this unit.
2
Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and GND
terminals.
antenna lead wires into the AM ANT and GND
terminals.
3
Orient the AM loop antenna for the best
reception.
reception.
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A property installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
■
FREQUENCY STEP switch
(General model only)
(General model only)
Because the interstation frequency
spacing differs in different areas, set
the FREQUENCY STEP switch
(locating on the rear panel) according
to the frequency spacing in your area.
• North, Central and Sout h America: 100 kHz/10 kHz
• Other areas: 50 kHz/9 kHz
Before setting this switch, disconnect this unit’s AC power
cord from the wall outlet.
spacing differs in different areas, set
the FREQUENCY STEP switch
(locating on the rear panel) according
to the frequency spacing in your area.
• North, Central and Sout h America: 100 kHz/10 kHz
• Other areas: 50 kHz/9 kHz
Before setting this switch, disconnect this unit’s AC power
cord from the wall outlet.
Connecting the antennas
AM ANT
GND
TUNER
75
Ω
UNBAL
FM ANT
AM loop antenna
(included)
Ground (GND terminal)
For maximum safety and minimum interference,
connect the antenna
connect the antenna
GND terminal to a good earth
ground. A good earth ground is a metal stake driven
into moist earth.
into moist earth.
Indoor FM
antenna
(included)
antenna
(included)
Notes
100kHz/10kHz
FREQUENCY
STEP
50kHz/9kHz
FM
FM
AM
00EN.00_RXZ9_U.book Page 28 Friday, October 17, 2003 11:40 AM