Yamaha ns-p620 Manual Do Proprietário
E-
8
For connections, keep the speaker cables as short as
possible. Do not bundle or roll up the excess part of the
cables. If the connections are faulty, no sound will be heard
from the speakers. Make sure that the + and – polarity
markings of the speaker cables are observed and set
correctly. If these cables are reversed, the sound will be
unnatural and lack bass.
possible. Do not bundle or roll up the excess part of the
cables. If the connections are faulty, no sound will be heard
from the speakers. Make sure that the + and – polarity
markings of the speaker cables are observed and set
correctly. If these cables are reversed, the sound will be
unnatural and lack bass.
How to Connect:
1
Loosen the knob.
2
Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
speaker cable by twisting the coating off.
3
Insert the bare wire.
4
Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
When using a banana plug
<
U.S.A., Canada, Australia, China and General models
only
>
(Main/center/rear speakers)
1
Remove the cover by pulling it toward you.
2
Tighten the terminal knob.
3
Simply insert the banana plug into the terminal.
(Subwoofer)
1
Tighten the terminal knob.
2
Simply insert the banana plug into the terminal.
1
2
3
Subwoofer (INPUT1/OUTPUT terminals)
Red: positive (+)
Black: negative (–)
Black: negative (–)
Main/center/rear speakers
Red: positive (+)
Black: negative (–)
Black: negative (–)
1
2
3
4
䡵 How to connect speaker cables
2
3
1
Banana plug
Banana plug
1
1
3
4
NS-P620UA(02.4.4)b
02.4.4, 10:58 PM
8