Kenwood vr-7060 Manual Do Utilizador

3 Use the ∧/∨ keys or @/# keys to select the speakers and the

%/fi) keys to adjust the

The speaker indicator to be adjusted blinks.

• The allowable setting range is 1 to 30 feet (0.3 to 9.0 m),

adjustable in 1 foot (0.3 m) increments.

4 Repeat steps 3 to input the distance for each of the speakers.

5 Press the SETUP key again to return to main setup displays.

• The speakers you have selected should appear on the display.

Confirm that all the speakers have been correctly selected.

7

1 Press the ∧/∨ key or @/# keys to select the DISP MODE.
2 Press the SETUP key for the following displays:

1 DISP SELECTOR

: Displays the current input selector.

2 DISP LISTEN

: Displays the current listen mode.

3 Use the MULTI CONTROL knob or Multi (%/fi) keys to select

4 Press the SETUP key again to accept the setting.
5 Use the ∧ key or # key to select EXIT.

6 Press the SETUP key to exit the SET UP mode.

If the input level of an analog source signal is too high, the CLIP indicator
will blink to indicate the source signal. Adjust the input level.

1 Use the Input Selector keys to select the source of which the

• You can store a separate input level for each input source.

2 Press the SOUND and ∧/∨ keys or @/# keys repeatedly until

3 Use the MULTI CONTROL knob or Multi (%/fi) keys to adjust the

• The adjustment mode is displayed for approximately 8 seconds.
• The input level may be adjusted to any one of three settings:

0dB, -3dB, and -6dB. (The initial setting is 0dB.)

4 Press the SOUND key again to return to the input indication.

Some preparatory steps are needed before starting playback.

1 Turn on the power to the related components.

2 Turn on the power to this receiver by pressing the POWER

If you have selected a component connected to the CD/DVD, VIDEO 2,
VIDEO 3 or DVD/6CH jacks, make sure that the input mode setting is
correct for the type of audio signal to be used.

8

Select the source name corresponding to the component connected
to the MD/TAPE jacks. The initial factory setting is “TAPE”. To
change the source to “MD”, follow the steps below:

• The source indication changes to “MD”.
• To return to the original indication, repeat the above procedure.

Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.

Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel. No sound will be heard from
the subwoofer.

Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.

No sound from the speakers. Use this setting when
listening with headphones for stereo sound in all playback
modes. The display segments are different depending on
the type of input signal.

The indicator for the speakers
you want to use should be lit.

• Selecting “6CH INPUT” by pressing the INPUT MODE key, whereby

“DVD/6CH” is the input source will cause SPEAKERS A to be selected
automatically.

Indication in feet

Indication in meters