Korg MICRO Manual Do Utilizador

Selects whether MIDI system exclusive messages will be transmitted and 
received.
DISABLE: MIDI system exclusive messages will not be transmitted or 
received.
ENABLE: MIDI system exclusive messages will be transmitted and 
received.

In this page you can specify the function that is assigned for modulation 
sources MIDI1, MIDI2, and MIDI3 used in a virtual patch.

If the selected function is assigned to a different parameter, an asterisk 
“*” is shown at the right of the value.

 

Selects the function that will be assigned to modulation source MIDI1 used 
in a virtual patch. The factory-set default setting is CC#16.

 

Selects the function that will be assigned to modulation source MIDI2 used 
in a virtual patch. The factory-set default setting is CC#02.

 

Selects the function that will be assigned to modulation source MIDI3 used 
in a virtual patch. The factory-set default setting is A.TOUCH (aftertouch).

Select “#016±”

Select “#016”

0

0

When a control change message is received from a 
slider (value 0—127) on an external MIDI device, the 
center position of the slider (control change value 64) 
will produce a modulation effect of 0 on the 
microKORG XL.
If you’ve selected #016, #017, #019, #020, or #021, 
setting the slider etc. to a position of 0 (control 
change value 0) will produce a modulation effect of 0 
on the microKORG XL. Choose the type of setting that will produce the 
desired result on the microKORG XL when you operate the sliders or other 
controllers of your external MIDI device.

Here you can assign control change numbers to the most important param-
eters. When you use performance editing or program editing, using the 
knob for these parameters will transmit the control change message that is 
assigned here. When the assigned control change message is received, 
the value of the corresponding parameter will change (J p. 83 “2.MIDI mes-
sages”).

Selects the knob parameter (J p. 34 “KNOB”).

Specifies a MIDI control change number (CC#) for the parameter selected 
by “Parameter.”

If another parameter is assigned to the number you select, an asterisk “*” 
will appear at the right of the number.

The MIDI channel for vocoder parameters will be the same MIDI channel 
as for timbre 1.