Zhone 2000 Manual Do Utilizador

- 123 -

Having many bridges creates the potential for network loops. A loop 
presents conflicting information about the segment on which a specific 
address is located and forces the bridge to forward all data. 

When configuring the IAD as a router (Chapter 4, 

), you must disable STP both globally and by port. 

To enable or disable STP globally:

1. On the Bridge Configuration menu, type T to select Enable/Disable 

Spanning Tree Globally.
The IAD displays the status of bridging, and a prompt:
Spanning Tree is Globally DISABLED
Enter E to Enable, D to Disable:

Type E to enable spanning tree globally, or D to disable it globally.

2. The IAD saves, then displays the Bridge Configuration menu.
3. Continue with other tasks, or press Escape to return to the Main menu.
4. Reset the IAD (page

) when you finish bridge configuration.

To enable or disable STP by port:

1. On the Bridge Configuration menu, type O to select Enable/Disable 

Spanning Tree by Port.

2. The IAD displays the interfaces available on this IAD, and a prompt:

Available Interfaces:

1. G2237 xDSL
2. 10/100BaseT Ethernet
0. (Abort)

Type the number of the port for which you want to enable STP.

3. If more than one interface is configured on the selected port, the IAD 

displays a list of interfaces:
Port

DLCI

Encapsulation

1

18

Proprietary Voice DLCI

Type the number of the port.

4. The IAD displays the status of this interface and port, and a prompt:

Spanning tree over T1/E1 Port 1, is currently 
DISABLED
Enter E to Enable, D to Disable:

Type E to enable STP on this port, or D to disable it. 

5. The IAD saves, then displays the Bridge Configuration menu.
6. Repeat these steps for each port you want to enable or disable STP.
7. Reset the IAD (page

) when you finish bridge configuration.

 

When you enable STP, the IAD reconfigures the bridge 
network to transfer data along an optimum route to its 
destination.