Zhone 5100 Guia Da Instalação
CHAPTER 4
Configuring a VDR
Configuring a VDR
42
Vpacket 5100/6100 Series Installer’s Guide
3. To set the voice IP interface, issue set ip voice 205.176.94.11
Note. You can also use the command set ip <lan | wan>.
wan sets the IP address to match the already configured WAN IP address
lan sets the IP address to match the already configured LAN IP address
4. Issue the show ip command and verify the changes.
Example:
Example:
5. Issue commit ip to force the changes to the Flash memory.
6. Issue the save command to write the commands to the Flash memory.
6. Issue the save command to write the commands to the Flash memory.
Note. Stop here and proceed to either the H.323 or SIP sections on the
documentation CD-ROM if you intend to use the 5100/6100 VDR to support H.323
or SIP.
7. To support MGCP, the version, endpoint ID, and notify entity values need to be defined.
a. Access the telephony submenu by entering telephony.
b. At the
b. At the
telephony
# prompt, issue one of the following:
-- set xgcp mgcp_version <1> to support MGCP version 1.0
-- set xgcp mgcp_version 2 to support MGCP NCS 1.0
-- set xgcp mgcp_version 2 to support MGCP NCS 1.0
c. Enter endpoint address of the softswitch/Call Agent according to that device’s numbering
scheme by issuing set tcid <tcid#> endpoint_id <ID number>
d. Enter the following command to define the device to be notified that the 5100/6100
VDR is now active: set tcid <tcid#> notify_entity <IP address:port number of the
Call Agent) <dynamic| static>
-- dynamic
-- dynamic
makes the VDR accept calls from all known Call Agents
-- static
makes the VDR accept calls only from the Call Agent it is pointing to
(the one identified in the IP address given earlier in the command).
(the one identified in the IP address given earlier in the command).
VPacket# show ip
ACTIVE indicates this is the current operational setting
CONFIG indicates this has been configured but not activated
-------------------------IP INTERFACE----------------------
INTERFACE NAME IP ADDRESS NET MASK
ACTIVE lan 10.10.10.254 255.255.255.0 Not NATed
ACTIVE wan 205.176.94.11 255.255.255.0
CONFIG Default Gateway 1.1.1.254
ACTIVE Voice Ip Address 205.176.94.11
-----------------------------------------------------------
VPacket#