Zhone 6210 Guia Do Utilizador

 6211-I1 ADSL2+ Router User’s Guide

3

1 Read and follow all warning notices and instructions marked on the 

product or included in the manual.

2 Slots and openings in the cabinet are provided for ventilation. To ensure 

reliable operation of the product and to protect it from overheating, these 

slots and openings must not be blocked or covered.

3 Do not allow anything to rest on the power cord and do not locate the 

product where persons will walk on the power cord.

4 Do not attempt to service this product yourself, as opening or removing 

covers may expose you to dangerous high voltage points or other risks. 

Refer all servicing to qualified service personnel.

5 General purpose cables are used with this product for connection to the 

network. Special cables, which may be required by the regulatory 

inspection authority for the installation site, are the responsibility of the 

customer. Use a UL Listed, CSA certified, minimum No. 24 AWG line 

cord for connection to the Digital Subscriber Line (DSL) network.

6 When installed in the final configuration, the product must comply with 

the applicable Safety Standards and regulatory requirements of the 

country in which it is installed. If necessary, consult with the appropriate 

regulatory agencies and inspection authorities to ensure compliance.

7 A rare phenomenon can create a voltage potential between the earth 

grounds of two or more buildings. If products installed in separate 

buildings are interconnected, the voltage potential may cause a hazardous 

condition. Consult a qualified electrical consultant to determine whether 

or not this phenomenon exists and, if necessary, implement corrective 

action prior to interconnecting the products.

8 Input power to this product must be provided by one of the following: (1) 

a UL Listed/CSA certified power source with a Class 2 or Limited Power 

Source (LPS) output for use in North America, or (2) a certified 

transformer, with a Safety Extra Low Voltage (SELV) output having a 

maximum of 240 VA available, for use in the country of installation.

9 In addition, since the equipment is to be used with telecommunications 

circuits, take the following precautions:
— Never install telephone wiring during a lightning storm.
— Never install telephone jacks in wet locations unless the jack is 

specifically designed for wet locations.

— Never touch uninsulated telephone wires or terminals unless the 

telephone line has been disconnected at the network interface.

— Use caution when installing or modifying telephone lines.
— Avoid using a telephone (other than a cordless type) during an 

electrical storm. There may be a remote risk of electric shock from 

lightning.

— Do not use the telephone to report a gas leak in the vicinity of the 

leak.