Zhone 1813 Guia Do Utilizador

The Command Line Interface (CLI) can be used to configure your endpoint device. Telnet is 
used to access the CLI.  

To Telnet to the device, you can either set your PC’s IP address to the same domain as the 
endpoint, or set the endpoint’s IP address to the same domain as your PC. The default IP address 
of the endpoint is 192.168.1.1.  

The timeout period of the Telnet session is three minutes. If no command is entered for three 
minutes, the Telnet session is terminated.  

To log on to the device using Telnet, your PC and the endpoint should both be on the same 
network segment. You can either modify the IP address of your PC to the same domain of the 
endpoint, or modify the IP address of the endpoint to the same domain as your PC. 

 

You can modify the IP address of the endpoint by completing the following steps:  

STEP 1: Enter a management tool (http or cli) for your endpoint  

STEP 2: Change the IP address to the same domain as your workstation.  

STEP 3: Save the settings to the flash and reboot the endpoint.