Zhone 1813 Guia Do Utilizador

To set up an IP address and subnet mask for the Ethernet interface, use the following command 
after the prompt of [1234 @ home]$.  

 

COMMAND DESCRIPTION 

<interface name> 

The LAN interface to be configured. Type eth0 for Interface Ethernet 1, and type eth0 for 
Interface Ethernet 2. 

The IP address or subnet mask to be assigned to the interface. Dot-notation is used to enter the IP 
address (for example 192.168.2.1).  

The netmask is used to extract the network portion of the IP address. It also specifies how much 
of the IP address is to be reserved for subdividing the network into sub networks, which are 
taken from the host field of the address. Netmask is added with the interface IP address to get a 
network ID that is used in routing to indicate that this network is reachable through these 
interfaces. The mask can be specified as a single hexadecimal number with a leading 0x for 
example 0xffffff00, or with a dot-notation Internet address 255.255.255.0 

alias <address> 

To add the alias IP address 

-alias <address> 

To delete the alias IP address 

 

To assign an IP address of 172.0.0.1 with a 24-bit subnet mask to the eth1 interface, use this 
command: 

 

After typing the command, the home prompt displays. Save the changes by typing save. The 
following message displays and shows that the changes are successful.