Zhone 6301 Instrução De Instalação

DSL LED is on and
there is no data
transmission.

The DSL link has been established but there is no data
transmission. First, verify the Ethernet connection. If the
problem persists, contact the service provider.

DSL & ETHERNET
LEDs are on and
there is no data
transmission.

The DSL link and the Ethernet link have been established but
there is no data transmission. If the problem continues, contact
the service provider.

ETHERNET LED is
off.

Verify that the Ethernet cable is securely installed at both ends,
and at least one PC is connected and powered on.

Verify that the correct straight-through or crossover cable is
installed. Refer to Installing the Hotwire 6301/6302 IDSL
Router on page 6.

PWR LED is off.

Check that the power cord is securely installed on both ends.

If no LEDs are on, the power supply may be defective. Test the
outlet to verify power. If the problem persists, contact the
service provider.

If other LEDs are on, the PWR LED may be burned out. Unplug
the unit and reapply power; watch all LEDs during the
power-on self-test to verify that the PWR LED is functioning.

TST LED is on.

A test initiated by the service provider may be active. Wait ten
minutes. If the TST LED does not go off, contact the service
provider.

The Console cable is connected to a VT100-compatible terminal or a PC running a
terminal emulation program. Verify the terminal settings:

H

Data rate set to 19.2 kbps (19200 bps)

H

Character length set to 8

H

Parity set to None

H

Stop bits set to 1

H

Flow control set to Off or None