Zhone 6301 Guia Do Utilizador

A. Command Line Interface

A-10

March

2002

6300-A2-GB20-00

Proxy ARP Command

arp create

ip-address

mac-address

arp delete

ip-address

Minimum Access Level: Administrator
Command Mode: Config

Creates or deletes a single, static Address Resolution Protocol (ARP) Table entry. Static
ARP entries created with this command are retained across resets/power cycles.

Examples:

arp create 132.53.4.2 00:10:4b:97:6c:44

arp delete 132.53.4.2

create – Create an ARP table entry. A maximum of 64 entries can be created.

delete – Delete an ARP table entry.

ip-address – The IP address of the ARP entry to be created or deleted.

mac-address – MAC address.

arp purge

Minimum Access Level: Administrator
Command Mode: Config

Deletes ALL static and dynamic ARP Table entries.

Table A-7.

ARP Commands (2 of 2)

Table A-8.

Proxy ARP Command

proxy arp

{

eth1

dsl1

}

[

enable

disable

]

Minimum Access Level: Administrator
Command Mode: Config

Enables or disables Proxy ARP for the specified interface. If enable or disable is not
entered, enable is assumed.

Example:

proxy arp dsl1 disable

eth1 – The Ethernet interface.

dsl1 – The DSL interface.

enable – Enable Proxy ARP.

disable – Disable Proxy ARP. This is the default setting.

NOTE: Proxy ARP and NAPT cannot be enabled at the same time. When Basic NAT is
enabled, Proxy ARP is allowed on the dsl1 interface.