Zhone 6350-a4 Instrução De Instalação

6350-A2-ZN12-30

15

Read and follow all warning notices and instructions marked on the product or included in 

the manual.

Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation 

of the product and to protect it from overheating, these slots and openings must not be 

blocked or covered.

Do not allow anything to rest on the power cord and do not locate the product where persons 

will walk on the power cord.

Do not attempt to service this product yourself, as opening or removing covers may expose 

you to dangerous high voltage points or other risks. Refer all servicing to qualified service 

personnel.

General purpose cables are used with this product for connection to the network. Special 

cables, which may be required by the regulatory inspection authority for the installation site, 

are the responsibility of the customer. Use a UL Listed, CSA certified, minimum No. 24 

AWG line cord for connection to the Digital Subscriber Line (DSL) network.

When installed in the final configuration, the product must comply with the applicable 

Safety Standards and regulatory requirements of the country in which it is installed. If 

necessary, consult with the appropriate regulatory agencies and inspection authorities to 

ensure compliance.

A rare phenomenon can create a voltage potential between the earth grounds of two or more 

buildings. If products installed in separate buildings are interconnected, the voltage 

potential may cause a hazardous condition. Consult a qualified electrical consultant to 

determine whether or not this phenomenon exists and, if necessary, implement corrective 

action prior to interconnecting the products.

Input power to this product must be provided by one of the following: (1) a UL Listed/CSA 

certified power source with a Class 2 or Limited Power Source (LPS) output for use in 

North America, or (2) a certified transformer, with a Safety Extra Low Voltage (SELV) 

output having a maximum of 240 VA available, for use in the country of installation.

In addition, since the equipment is to be used with telecommunications circuits, take the 

following precautions:
— Never install telephone wiring during a lightning storm.
— Never install telephone jacks in wet locations unless the jack is specifically designed 

for wet locations.

— Never touch uninsulated telephone wires or terminals unless the telephone line has 

been disconnected at the network interface.

— Use caution when installing or modifying telephone lines.
— Avoid using a telephone (other than a cordless type) during an electrical storm. There 

may be a remote risk of electric shock from lightning.

— Do not use the telephone to report a gas leak in the vicinity of the leak.