Zhone 6381-a4-200 Guia Do Utilizador
6381-A4 Router Users Guide
112
the panic, alert, and critical levels.
Warning
Conditions that warrant monitoring.
Notice
Conditions that are not errors but might warrant special handling.
Info
Events or non-error conditions of interest.
Debug
Software debugging messages. Specify this level only if so directed by your
technical support representative.
technical support representative.
4.
In the Add an IP Address text box enter the destination IP address (if not already existing).
5.
From the Select a logging destination drop down, select a destination for the severity
level.
level.
6.
Click Apply
The Apply button will temporarily save this connection. To make the change permanent,
click Tools (at the top of the page) and select System Commands. On the System
Commands page, click Save All.
click Tools (at the top of the page) and select System Commands. On the System
Commands page, click Save All.
For PPPoE and PPPoA connections, select Debug if you want to log the connection information.
This is helpful when trying to debug connection problems. Verify that the Debug box is checked
on the PPPoA or PPPoE Connection Setup screen.
This is helpful when trying to debug connection problems. Verify that the Debug box is checked
on the PPPoA or PPPoE Connection Setup screen.
User Management
You can change your modem’s username, password and the idle timeout; you will need to log
back onto the modem once the timeout expires.
back onto the modem once the timeout expires.
If you forget your password, press and hold the reset to factory defaults button for 10 seconds.
The modem will reset to its factory default configuration and all custom configurations will be lost.
The modem will reset to its factory default configuration and all custom configurations will be lost.
To change user management settings:
1.
From the navigation bar at the top of the screen click Tools
2.
From the left hand navigation pane select User Management.
3.
To change the user name (from the default “Admin”): in the User Name text box enter a new
user name for the device.
user name for the device.
4.
To change the password (from the default “Admin”): In the Password text box enter the new
password, then again in the Confirm Password text box.
password, then again in the Confirm Password text box.
5.
To change the idle timeout settings: in the Idle Timeout text box enter the idle timeout
duration in minutes.
duration in minutes.
6.
Click Apply
The Apply button will temporarily save this connection. To make the change permanent,
click Tools (at the top of the page) and select System Commands. On the System
Commands page, click Save All.
click Tools (at the top of the page) and select System Commands. On the System
Commands page, click Save All.