Zhone 6381-a4-200 Guia Do Utilizador
6381-A4 Router Users Guide
21
Configuring Your Computer
Prior to accessing the modem through the LAN or the USB port, note the following necessary
configurations—
configurations—
• Your PC’s TCP/IP address: 192.168.1.__( the last number is any number between 2 and
254)
• The modem’s default IP address: 192.168.1.1
• Subnet mask: 255.255.255.0
• Subnet mask: 255.255.255.0
Below are the procedures for configuring your computer. Follow the instructions for the operating
system that you are using.
system that you are using.
If you used the Ethernet cable to connect your router and PC, you do not need any specific driver
installation and you can skip Windows USB Driver Installation, below. If you used the USB cable
on a PC running a Windows operation system, install the provided USB driver. Windows 95 and
Windows NT 4.0 do not support USB without additional software (not included with your router). If
USB driver installation fails under those operating systems, contact your service provider.
installation and you can skip Windows USB Driver Installation, below. If you used the USB cable
on a PC running a Windows operation system, install the provided USB driver. Windows 95 and
Windows NT 4.0 do not support USB without additional software (not included with your router). If
USB driver installation fails under those operating systems, contact your service provider.
Windows 2000
1.
In the Windows taskbar, click the Start button and point to Settings, Control Panel, and
Network and Dial-up Connections (in that order).
Network and Dial-up Connections (in that order).
2.
Click Local Area Connection. When you have the Local Area Connection Status window
open, click Properties.
open, click Properties.
3.
Listed in the window are the installed network components. If the list includes Internet
Protocol (TCP/IP), then the protocol has already been enabled, and you can skip to Step
10.
Protocol (TCP/IP), then the protocol has already been enabled, and you can skip to Step
10.
4.
If Internet Protocol (TCP/IP) does not appear as an installed component, then click Install.
5.
In the Select Network Component Type window, click on protocol and then the Add
button.
button.
6.
Select Internet Protocol (TCP/IP) from the list and then click on OK.
7.
If prompted to restart your computer with the new settings, click OK.
8.
After your computer restarts, click the Network and Dial-up Connections icon again, and
right click on the Local Area Connection icon and then select Properties.
right click on the Local Area Connection icon and then select Properties.
9.
In the Local Area Connection Properties dialog box, select Internet Protocol (TCP/IP)
and then click Properties.
and then click Properties.
10.
In the Internet Protocol (TCP/IP) Properties dialog box, click the radio button labelled Use
the following IP address and type 192.168.1.x (where x is any number between 2 and 254)
and 255.255.255.0 in the IP address field and Subnet Mask field.
the following IP address and type 192.168.1.x (where x is any number between 2 and 254)
and 255.255.255.0 in the IP address field and Subnet Mask field.
11.
Click OK twice to save your changes and then close the Control Panel.