Zhone 6381-a4-200 Guia Do Utilizador
6381-A4 Router Users Guide
96
Ingress
Configure Quality of Service (QoS) for packets entering the device. Ingress denotes packets
arriving into the 6381 from a WAN or LAN interface. The mappings are converted to CoS.
arriving into the 6381 from a WAN or LAN interface. The mappings are converted to CoS.
QoS can be configured on a per interface basis. Select the interface — USB, Ethernet, Bridge —
which needs to be configured.
which needs to be configured.
Ingress Untrusted Mode
Untrusted is the default Ingress page setting for all interfaces. In this mode, no domain mapping
is honoured in the RG. All packets are treated as CoS6 (best effort)
is honoured in the RG. All packets are treated as CoS6 (best effort)
Untrusted
The default Ingress page setting. No domain mapping is honoured. All packets are
treated as CoS6, the best effort priority.
treated as CoS6, the best effort priority.
Layer2
Enables you to map an incoming packet with layer 2 (MAC addresses and bridging,
rather than by IP address and routing) with VLAN segregation for priority. Only
configurable on WAN interfaces.
rather than by IP address and routing) with VLAN segregation for priority. Only
configurable on WAN interfaces.
Layer3
Enables you to map type of service (ToS) bits of incoming packets from the IP
network to CoS for each WAN/LAN interface.
network to CoS for each WAN/LAN interface.
Static
Enables you to configure a static CoS for all packets received on a WAN or LAN
interface.
interface.
To configure QoS on ingress:
1.
From the navigation bar at the top of the screen click Advanced
2.
From the left hand navigation pane select Ingress.
3.
On the Ingress page, select the interface from the Interface drop down.
4.
Select the appropriate Untrusted, Layer2, Layer3, or Static radio button.
5.
Click Apply