Zhone 7995 Instrução De Instalação

Send (AIS) on Network Failure

Possible Settings: Enable, Disable
Default Setting: Enable

Specifies the action taken on the signal transmitted to the G.703 when a valid signal
cannot be recovered from the network interface (LOS or OOF).

Primary Clock Source

Possible Settings: G.703, Internal
Default Setting: Internal

Specifies from where the unit will derive its timing.

Table 5. System Options (1 of 2)

DSL Mode

Possible Settings: STU-C, STU-R
Default Setting: STU-R

Controls whether the unit is configured as a SHDSL Transceiver Unit – Central Site
(STU-C) or a SHDSL Transceiver Unit – Remote Terminal Site (STU-R).

NOTE: Changing this option will reset the unit.

Test Timeout

Possible Settings: Enable, Disable
Default Setting: Enable

Allows tests to end automatically. The feature should be enabled when the unit is
remotely managed so that control can be regained after a test is accidentally
executed.

Test Duration (min)

Possible Settings: 1 – 120
Default Setting: 10

Number of minutes for a test to be active before automatically ending.

G.703 Line Termination

(Model 7996)
Possible Settings: 75 ohms, 120 ohms
Default Setting: 120 ohms

Sets the line impedance for the unit.

Table 4. G.703 Interface Options – Model 7996 (2 of 2)