Zhone 2208 Guia Do Utilizador

C o n f i g u r a t i o n

Select Individual Channels
1

Type “3” to enable or disable specific channels. If all channels are 

disabled, this option enables specific channels. Conversely, if all channels 

are enabled, this option disables specific channels.The IAD displays 

prompts you to select Channel Enable/Disable.

For each channel, type the number and press Enter. When you have entered 

all channels to enable or disable, press Enter. The IAD saves the 

configuration and displays the T1 Configuration menu.

Continue with other configuration tasks.

To select Channel Range, perform the following steps:

Type “4” to enable a range of channels. The IAD displays the channel 

status and prompts you to select a Channel Range and to type in the 

Beginning Channel.

Type the beginning channel and press Enter. The IAD prompts you to type 

in the Last Channel of Range.

Type the ending channel to enable and press Enter. The IAD makes the 

change and saves the configuration and displays the T1 Configuration 

menu.

Continue with other configuration tasks.

To Configure the Transmit Clock Source, follow the steps below.

Type “8” on the T1 Configuration menu to select Configure Transmit 

Clock Source, which will display the Select Tx Clock Source menu (Figure 

4.14) with a status message.

Type “1” to select External or Slave mode, or type “2” to select Internal 

or Master mode. The IAD saves the configuration and resets the interface.

Press Escape to return to the T1 Configuration menu and continue with 

other configuration tasks.

After you reset the IAD, you will see a prompt to type “1” to select 

External or “2” to select Internal mode. Enter your selection.

The IAD saves the configuration and resets the interface.