ZyXEL p-334 Manual Do Utilizador

Prestige 334 User’s Guide

Chapter 23 Remote Node Configuration

230

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to 
set the value to Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter. 

Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between 
this remote node and the Prestige to prevent certain packets from triggering calls. You can 
specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field. 
Note that spaces are accepted in this field. For more information on defining the filters, please 
refer to the Filters chapter. For PPPoE or PPTP encapsulation, you have the additional option 
of specifying remote node call filter sets.

Metric

Enter a number from 1 to 15 to set this route’s priority among the Prestige’s routes 

(see the Metric section in the WAN and Dial Backup Setup chapter) The smaller the 

number, the higher priority the route has.

Private

This field is valid only for PPTP/PPPoE encapsulation. This parameter determines if 

the Prestige will include the route to this remote node in its RIP broadcasts. If set to 

Yes, this route is kept private and not included in RIP broadcast. If No, the route to 

this remote node will be propagated to other hosts through RIP broadcasts.

RIP Direction

Press [SPACE BAR] and then [ENTER] to select the RIP direction from Both/ None/

In Only/Out Only. See the LAN Setup chapter for more information on RIP. The 

default for RIP on the WAN side is None. It is recommended that you do not change 

this setting.

Version

Press [SPACE BAR] and then [ENTER] to select the RIP version from RIP-1/RIP-2B/

RIP-2M or None.

Multicast

IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to 

establish membership in a Multicast group. The Prestige supports both IGMP version 

1 (IGMP-v1) and version 2 (IGMP-v2). Press [SPACE BAR] to enable IP Multicasting 

or select None to disable it. See the LAN Setup chapter for more information on this 

feature.

Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER] 

at the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or press 

[ESC] at any time to cancel.

Table 77   Remote Node Network Layer Options