ZyXEL NBG-318S Guia Do Utilizador

NBG-318S User’s Guide

DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual 
clients to obtain TCP/IP configuration at start-up from a server. You can configure the NBG-
318S as a DHCP server or disable it. When configured as a server, the NBG-318S provides the 
TCP/IP configuration for the clients. If DHCP service is disabled, you must have another 
DHCP server on your LAN, or else the computer must be manually configured.

Click Network > DHCP Server. The following screen displays.

Figure 60   Network > DHCP Server > General   

The following table describes the labels in this screen.

Table 42   Network > DHCP Server > General 

Enable DHCP Server

DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) 

allows individual clients (computers) to obtain TCP/IP configuration at startup 

from a server. Leave the Enable DHCP Server check box selected unless 

your ISP instructs you to do otherwise. Clear it to disable the NBG-318S 

acting as a DHCP server. When configured as a server, the NBG-318S 

provides TCP/IP configuration for the clients. If not, DHCP service is disabled 

and you must have another DHCP server on your LAN, or else the computers 

must be manually configured. When set as a server, fill in the following four 

fields.

IP Pool Starting 

Address

This field specifies the first of the contiguous addresses in the IP address 

pool.

Pool Size

This field specifies the size, or count of the IP address pool.

Apply

Click Apply to save your changes back to the NBG-318S.

Reset

Click Reset to begin configuring this screen afresh.