ZyXEL p-660r-t1 v2 Manual Do Utilizador

P-660R-Tx v2 Series User’s Guide

Chapter 2 Introducing the Web Configurator

37

1 Make sure the PWR/SYS LED is on (not blinking).

2 Press the RESET button for ten seconds or until the PWR/SYS LED begins to blink and 

then release it. When the PWR/SYS LED begins to blink, the defaults have been restored 
and the ZyXEL Device restarts.

The following summarizes how to navigate the web configurator from the SITE MAP screen. 

• Click Wizard Setup to begin a series of screens to configure your ZyXEL Device for the 

first time.

• Click a link under Advanced Setup to configure advanced ZyXEL Device features.
• Click a link under Maintenance to see ZyXEL Device performance statistics, upload 

firmware and back up, restore or upload a configuration file.

• Click SITE MAP to go to the Site Map screen.
• Click Logout in the navigation panel when you have finished a ZyXEL Device 

management session.

Figure 5    Web Configurator: Site Map Screen 

Click the 

 icon (located in the top right corner of most screens) to view embedded help. 

Table 3   Web Configurator Screens Summary

Wizard Setup

Connection 

Setup

Use these screens for initial configuration including general 

setup, ISP parameters for Internet Access and WAN IP/DNS 

Server/MAC address assignment.

Advanced Setup

Password

Use this screen to change your password.

LAN

Use this screen to configure LAN DHCP and TCP/IP settings.