ZyXEL NSA-2400 Guia Do Utilizador

Chapter 7 Storage Screens

NSA-2400 User’s Guide

Click the Create a New Internal Volume button in the Volume screen as shown in 

Figure 51   Create a New Internal Volume

 

The following table describes the labels in this screen.

 

Table 44   Create a New Internal Volume 

Volume Information 

 Volume Name 

Internal volume names are pre-defined. You cannot change them.

Snapshot Space

Type what percentage of the volume should be used for snapshots. 
Snapshots take up as much space as they need (within the reserved 
space). 

Note: Reserved snapshot space can not be increased later, 

so it's better to reserve enough space in the 
beginning. All snapshots are lost if you run out of disk 
space. 

Disk Configuration

Use JBOD or RAID 0 if you want maximum capacity and/or maximum 
speed for your disks, and/or you have other means of protecting your 
data. 
Use RAID 1 if you want to mirror primary data to another disk(s) with high 
performance. 
Use RAID 10, RAID 5 or RAID%_SPARE if you have four disks and you 
want to balance performance, hard disk capacity usage with data 
protection in case of disk failure.
See 

 and 

 for more 

information on storage systems.

Disk Selection

Internal Disk:

This table lists all hard disks installed inside the NSA. Use the Selection 
check box(es) to choose which disks should make up this volume. A disk 
can only belong to one volume.

Apply

Click this button to save your changes back to the NSA. 

Cancel

Click this button to begin configuring this screen afresh.