ZyXEL P-791R v2 Guia Do Utilizador

P-791R v2 Support Notes

The P-791R v2 supports NAT sets on a remote node basis. They are reusable,
but only one set is allowed for each remote node. The P-791R v2 supports 8
sets since there are 8 remote nodes.

By fatory default, the NAT is select as SUA in Web Configurator, Advanced
Setup, Network -> NAT -> General -> NAT Setup.

11. Is it possible to access a server running behind SUA from the outside

Internet? If possible, how?

Yes, it is possible because P-791R v2 delivers the packet to the local server by
looking up to a SUA server table. Therefore, to make a local server accessible
to the outside users, the port number and the inside IP address of the server
must be configured. (You can configure it in Web Configurator, Advanced
Setup, Network -> NAT -> Port Forwarding.

12. When do I need to select Full Feature NAT?

•

Make multiple local servers on the LAN accessible from outside with
multiple global IP addresses

With SUA, 'visible' servers had to be mapped to different ports, since the
servers share only one global IP. But when you select Full Feature, you can
make multiple local servers (mapping the same port or not) on the LAN
accessible from outside with multiple global IP addresses.

•

Support Non-NAT Friendly Applications

Some servers providing Internet applications such as some MIRC servers do
not allow users to login using the same IP address. Thus, users on the same
network can not login to the same server simultaneously. In this case it is
better to use Many-to-Many No Overload or One-to-One NAT mapping types,
thus each user login to the server using a unique global IP address.