ZyXEL nbg-334sh Manual Do Utilizador

Appendix E Setting up Your Computer’s IP Address

ZyXEL NBG-334SH User’s Guide

2 If you know your DNS server IP address(es), enter the DNS server information in the 

resolv.conf

 file in the 

/etc

 directory.  The following figure shows an example 

where two DNS server IP addresses are specified.

Figure 149   Red Hat 9.0: DNS Settings in resolv.conf   

3 After you edit and save the configuration files, you must restart the network card. Enter 

./network restart

 in the 

/etc/rc.d/init.d 

directory.  The following figure 

shows an example.

Figure 150   Red Hat 9.0: Restart Ethernet Card  

Enter 

ifconfig

 in a terminal screen to check your TCP/IP properties.  

Figure 151   Red Hat 9.0: Checking TCP/IP Properties  

nameserver 172.23.5.1
nameserver 172.23.5.2

[root@localhost init.d]# network restart

Shutting down interface eth0:                 [OK]
Shutting down loopback interface:             [OK]
Setting network parameters:                   [OK]
Bringing up loopback interface:               [OK]
Bringing up interface eth0:                   [OK]

[root@localhost]# ifconfig 
eth0      Link encap:Ethernet  HWaddr 00:50:BA:72:5B:44  
          inet addr:172.23.19.129  Bcast:172.23.19.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:717 errors:0 dropped:0 overruns:0 frame:0
          TX packets:13 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          RX bytes:730412 (713.2 Kb)  TX bytes:1570 (1.5 Kb)
          Interrupt:10 Base address:0x1000 
[root@localhost]#