ZyXEL p-2802h-i1 Manual Do Utilizador

 Chapter 7 LAN Setup

P-2802H(W)(L)-I Series User’s Guide

Use this screen to edit your ZyXEL Device's RIP, multicast, any IP and Windows Networking 
settings. Click the Advanced Setup button in the LAN IP screen. The screen appears as 
shown.

Figure 43   Advanced LAN Setup

The following table describes the labels in this screen.  

Cancel

Click Cancel to begin configuring this screen afresh.

Advanced Setup

Click this button to display the Advanced Setup screen and edit more details of 

your LAN setup.

Table 23   LAN IP (continued)

Table 24   Advanced LAN Setup

RIP & Multicast 

Setup

RIP Direction

Select the RIP direction from None, Both, In Only and Out Only.

RIP Version

Select the RIP version from RIP-1, RIP-2B and RIP-2M.

Multicast

IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to 

establish membership in a multicast group. The ZyXEL Device supports both IGMP 

version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.

Any IP Setup

Select the Active check box to enable the Any IP feature. This allows a computer 

to access the Internet without changing the network settings (such as IP address 

and subnet mask) of the computer, even when the IP addresses of the computer 

and the ZyXEL Device are not in the same subnet. 

Note: You must enable NAT/SUA to use the Any IP feature on the 

ZyXEL Device.

When you disable the Any IP feature, only computers with dynamic IP addresses or 

static IP addresses in the same subnet as the ZyXEL Device’s LAN IP address can 

connect to the ZyXEL Device or access the Internet through the ZyXEL Device.