ZyXEL p-334wh Guia Do Utilizador

Página de 289
P-334WH User’s Guide
 Certifications
Certifications
Federal Communications Commission (FCC) Interference Statement
The device complies with Part 15 of FCC rules. Operation is subject to the following two 
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause 
undesired operations.
This device has been tested and found to comply with the limits for a Class B digital device 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This device generates, 
uses, and can radiate radio frequency energy, and if not installed and used in accordance with 
the instructions, may cause harmful interference to radio communications. However, there is 
no guarantee that interference will not occur in a particular installation.
If this device does cause harmful interference to radio/television reception, which can be 
determined by turning the device off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver 
is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
• The device complies with FCC RF radiation exposure limits set forth for an uncontrolled 
environment, under 47 CFR 2.1093 paragraph (d)(2). End users must follow the specific 
operating instructions for satisfying RF exposure compliance.
 
To maintain compliance 
with FCC RF exposure compliance requirements, please follow operation instruction as 
documented in this manual. 
• This transmitter must not be co-located or operating in conjunction with any other 
antenna or transmitter.
• IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to 
channels 1 through 11. 
• To comply with FCC RF exposure compliance requirements, a separation distance of at 
least 20 cm must be maintained between the antenna of this device and all persons.