ZyXEL NBG-419N Guia Do Utilizador

 Appendix C Setting up Your Computer’s IP Address

NBG-419N User’s Guide

• If you have a static IP address, enter static in the BOOTPROTO= field. Type 

IPADDR= followed by the IP address (in dotted decimal notation) and type 
NETMASK= followed by the subnet mask. The following example shows an 

example where the static IP address is 192.168.1.10 and the subnet mask is 

255.255.255.0. 

Figure 165   Red Hat 9.0: Static IP Address Setting in ifconfig-eth0   

If you know your DNS server IP address(es), enter the DNS server information in 
the resolv.conf file in the /etc directory. The following figure shows an example 
where two DNS server IP addresses are specified.

Figure 166   Red Hat 9.0: DNS Settings in resolv.conf   

After you edit and save the configuration files, you must restart the network card. 
Enter./network restart in the /etc/rc.d/init.d directory. The following 
figure shows an example.

Figure 167   Red Hat 9.0: Restart Ethernet Card 

DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=192.168.1.10
NETMASK=255.255.255.0
USERCTL=no
PEERDNS=yes
TYPE=Ethernet

nameserver 172.23.5.1
nameserver 172.23.5.2

[root@localhost init.d]# network restart

Shutting down interface eth0:                 [OK]
Shutting down loopback interface:             [OK]
Setting network parameters:                   [OK]
Bringing up loopback interface:               [OK]
Bringing up interface eth0:                   [OK]