ZyXEL p-2302hw-p1 Manual Do Utilizador
P-2302HW/HWL-P1 Series User’s Guide
224
Chapter 18 Remote MGMT
18.3.2 SNMP Traps
The ZyXEL Device will send traps to the SNMP manager when any one of the following
events occurs:
events occurs:
18.3.3 Configuring SNMP
To change your ZyXEL Device’s SNMP settings, click Advanced > Remote MGMT >
SNMP. The screen appears as shown.
SNMP. The screen appears as shown.
Use this screen to control SNMP access to your ZyXEL Device. To access this screen, click
Management > Remote MGMT > SNMP.
Management > Remote MGMT > SNMP.
Table 98 SNMP Traps
TRAP #
TRAP NAME
DESCRIPTION
0
coldStart (defined in RFC-1215)
A trap is sent after booting (power on).
1
warmStart (defined in RFC-1215)
A trap is sent after booting (software reboot).
4
authenticationFailure (defined in
RFC-1215)
RFC-1215)
A trap is sent to the manager when receiving any
SNMP get or set requirements with the wrong
community (password).
SNMP get or set requirements with the wrong
community (password).
6
whyReboot (defined in ZYXEL-
MIB)
MIB)
A trap is sent with the reason of restart before
rebooting when the system is going to restart (warm
start).
rebooting when the system is going to restart (warm
start).
6a
For intentional reboot:
A trap is sent with the message "System reboot by
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
6b
For fatal error:
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
system reboots because of fatal errors.