ZyXEL p-2302hw-p1 Manual Do Utilizador

P-2302HW/HWL-P1 Series User’s Guide

Chapter 5 Wireless LAN

93

Figure 39   Wireless LAN: General 

The following table describes the general wireless LAN labels in this screen.

Select No Security to allow wireless stations to communicate with the access points without 
any data encryption. 

Table 34   Wireless LAN: General

Enable 
Wireless LAN

Click the check box to activate wireless LAN.

Name(SSID)

(Service Set IDentity) The SSID identifies the Service Set with which a wireless 
station is associated. Wireless stations associating to the access point (AP) must 
have the same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII 
characters) for the wireless LAN. 

Note: If you are configuring the ZyXEL Device from a computer 

connected to the wireless LAN and you change the ZyXEL 
Device’s SSID or WEP settings, you will lose your wireless 
connection when you press Apply to confirm. You must then 
change the wireless settings of your computer to match the 
ZyXEL Device’s new settings.

Hide SSID

Select this check box to hide the SSID in the outgoing beacon frame so a station 
cannot obtain the SSID through scanning using a site survey tool.

Channel 
Selection

If two wireless networks overlap, they should use a different channel.

Like radio stations or television channels, each wireless network uses a specific 
channel, or frequency, to send and receive information.

Select a channel from the drop-down list box. 

Security Mode

See the following sections for more details about this field.

Apply

Click Apply to save your changes back to the ZyXEL Device.

Cancel

Click Cancel to reload the previous configuration for this screen.