ZyXEL NBG-416N Guia Do Utilizador
Chapter 5 AP Mode
NBG-416N User’s Guide
54
Note: If you change the IP address of the NBG-416N in the screen below, you will
need to log into the NBG-416N again using the new IP address.
Figure 28 Network > LAN > IP
The table below describes the labels in the screen.
5.4.2 WLAN and Maintenance Settings
The configuration of wireless and maintenance settings in AP Mode is the same as
for Router Mode.
for Router Mode.
• See
Chapter 5 on page 69
for information on the configuring your wireless
network.
• See
for information on configuring your maintenance
settings.
5.5 Logging in to the Web Configurator in AP
Mode
Mode
1
Connect your computer to the LAN port of the NBG-416N.
Table 21 Network > LAN > IP
LABEL
DESCRIPTION
Get from DHCP
Server
Server
Select this to let the DHCP server in the gateway assign the NBG-
416N IP address.
416N IP address.
User Defined LAN IP
Select this to give the NBG-416N a static IP address.
IP Address
Type the IP address in dotted decimal notation. The default
setting is 192.168.1.2. If you change the IP address you will have
to log in again with the new IP address.
setting is 192.168.1.2. If you change the IP address you will have
to log in again with the new IP address.
IP Subnet Mask
The subnet mask specifies the network number portion of an IP
address. Your NBG-416N will automatically calculate the subnet
mask based on the IP address that you assign. Unless you are
implementing subnetting, use the subnet mask computed by the
NBG-416N.
address. Your NBG-416N will automatically calculate the subnet
mask based on the IP address that you assign. Unless you are
implementing subnetting, use the subnet mask computed by the
NBG-416N.
Apply
Click Apply to save your changes to the NBG-416N.
Reset
Click Reset to reload the previous configuration for this screen.