ZyXEL p-2802h-i1 Guia Do Utilizador

Chapter 23 Tools

P-2802H(W)(L)-I Series User’s Guide

computer and renames it “

config.rom

”. See earlier in this chapter for more 

information on filename conventions.

7 Enter “

quit

” to exit the ftp prompt. 

This figure gives an example of using FTP commands from the DOS command prompt to save 
your device’s configuration onto your computer. 

Figure 193   FTP Session Example

The following table describes some of the commands that you may see in GUI-based FTP 
clients.

The ZyXEL Device supports the up/downloading of the firmware and the configuration file 
using TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP should work over 
WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To backup the 
configuration file, follow the procedure shown next.

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit

Table 142   General Commands for GUI-based FTP Clients

Host Address

Enter the address of the host server.

Login Type

Anonymous.
This is when a user I.D. and password is automatically supplied to the 

server for anonymous access.  Anonymous logins will work only if your 

ISP or service administrator has enabled this option.
Normal.  
The server requires a unique User ID and Password to login.

Transfer Type

Transfer files in either ASCII (plain text format) or in binary mode.

Initial Remote Directory

Specify the default remote directory (path).

Initial Local Directory

Specify the default local directory (path).