ZyXEL p-660hwp Guia Do Utilizador

Chapter 9 Network Address Translation (NAT)

P-660HWP-Dx User’s Guide

Figure 88   NAT Port Forwarding

The following table describes the fields in this screen. 

To edit a port forwarding rule, click the rule’s edit icon (

) in the Port Forwarding screen 

to display the screen shown next. 

Table 51   NAT Port Forwarding

Default Server 

Setup

Default Server

In addition to the servers for specified services, NAT supports a default server. A 

default server receives packets from ports that are not specified in this screen. If 

you do not assign a Default Server IP address, the P-660HWP-Dx discards all 

packets received for ports that are not specified here or in the remote 

management setup.

Port Forwarding

Service Name

Select a service from the drop-down list box.

Server IP 

Address

Enter the IP address of the server for the specified service.

Add

Click this button to add a rule to the table below.

#

This is the rule index number (read-only).

Active

Click this check box to enable the rule.

Service Name

This is a service’s name.

Start Port 

This is the first port number that identifies a service.

End Port 

This is the last port number that identifies a service.

Server IP 

Address

This is the server’s IP address.

Modify

Click the edit icon to go to the screen where you can edit the port forwarding rule.
Click the delete icon to delete an existing port forwarding rule. Note that 

subsequent rules move up by one when you take this action.

Apply

Click Apply to save your changes to the P-660HWP-Dx.

Cancel

Click Cancel to return to the previous configuration.