ZyXEL p-660hwp Guia Do Utilizador

 Appendix D Setting up Your Computer’s IP Address

P-660HWP-Dx User’s Guide

Figure 207   Red Hat 9.0: Dynamic IP Address Setting in ifconfig-eth0  

• If you have a static IP address, enter 

 in the 

BOOTPROTO=

 field. Type 

IPADDR

= followed by the IP address (in dotted decimal notation) and type 

NETMASK

= 

followed by the subnet mask. The following example shows an example where the 
static IP address is 192.168.1.10 and the subnet mask is 255.255.255.0. 

Figure 208   Red Hat 9.0: Static IP Address Setting in ifconfig-eth0   

2 If you know your DNS server IP address(es), enter the DNS server information in the 

resolv.conf

 file in the 

/etc

 directory. The following figure shows an example where 

two DNS server IP addresses are specified.

Figure 209   Red Hat 9.0: DNS Settings in resolv.conf   

3 After you edit and save the configuration files, you must restart the network card. Enter 

./network restart

 in the 

/etc/rc.d/init.d 

directory. The following figure 

shows an example.

Figure 210   Red Hat 9.0: Restart Ethernet Card  

DEVICE=eth0
ONBOOT=yes
BOOTPROTO=dhcp
USERCTL=no
PEERDNS=yes
TYPE=Ethernet

DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=192.168.1.10
NETMASK=255.255.255.0
USERCTL=no
PEERDNS=yes
TYPE=Ethernet

nameserver 172.23.5.1
nameserver 172.23.5.2

[root@localhost init.d]# network restart

Shutting down interface eth0:                 [OK]
Shutting down loopback interface:             [OK]
Setting network parameters:                   [OK]
Bringing up loopback interface:               [OK]
Bringing up interface eth0:                   [OK]