ZyXEL p-660hwp Guia Do Utilizador
Chapter 2 Introducing the Web Configurator
P-660HWP-Dx User’s Guide
38
2.3 Resetting the P-660HWP-Dx
If you forget your password or cannot access the web configurator, you will need to use the
RESET button at the back of the P-660HWP-Dx to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously and the password
will be reset to “1234”.
RESET button at the back of the P-660HWP-Dx to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously and the password
will be reset to “1234”.
2.3.1 Using the Reset Button
1 Make sure the POWER LED is on (not blinking).
2 Press the RESET button for ten seconds or until the POWER LED begins to blink and
2 Press the RESET button for ten seconds or until the POWER LED begins to blink and
then release it. When the POWER LED begins to blink, the defaults have been restored
and the P-660HWP-Dx restarts.
and the P-660HWP-Dx restarts.
2.4 Navigating the Web Configurator
2.4.1 Navigation Panel
After you enter the admin password, use the sub-menus on the navigation panel to configure
P-660HWP-Dx features. The following table describes the sub-menus.
P-660HWP-Dx features. The following table describes the sub-menus.
Figure 12 Web Configurator: Main Screen
Use the
submenus
to configure
P-660HWP-
Dx features.
Click the logout icon any time to
exit the web configurator