ZyXEL p-660hwp Guia Do Utilizador

 Chapter 5 WAN Setup

P-660HWP-Dx User’s Guide

Multiplexing

Select the method of multiplexing used by your ISP from the drop-down list. 

Choices are VC or LLC.
By prior agreement, a protocol is assigned a specific virtual circuit, for example, 

VC1 will carry IP. If you select VC, specify separate VPI and VCI numbers for 

each protocol.
For LLC-based multiplexing or PPP encapsulation, one VC carries multiple 

protocols with protocol identifying information being contained in each packet 

header. In this case, only one set of VPI and VCI numbers need be specified for 

all protocols.

VPI

The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.

VCI

The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local 

management of ATM traffic). Enter the VCI assigned to you.

IP Address

This option is available if you select Routing in the Mode field.

Obtain an IP 

Address 

Automatically

Select this if you get a dynamic IP address from your Internet Service Provider 

(ISP). A dynamic IP address is not fixed; your ISP assigns you a different one 

each time you connect to the Internet. 
This option is not available if you select RFC 1483 in the Encapsulation field.

Static IP Address

Select this if your ISP gave you a fixed IP address. Enter the IP address you 

were given in the IP Address field.

IP Address

If your ISP gave you an IP address to use, enter it here.

Subnet Mask 

Enter a subnet mask in dotted decimal notation. 
Refer to the appendices to calculate a subnet mask If you are implementing 

subnetting.

Gateway IP address Specify a gateway IP address (supplied by your ISP).

Connection

Nailed-Up 

Connection

Select Nailed-Up Connection when you want your connection up all the time. 

The P-660HWP-Dx will try to bring up the connection automatically if it is 

disconnected.

Connect on 

Demand

Select Connect on Demand when you don't want the connection up all the time 

and specify an idle time-out in the Max Idle Timeout field.

Max Idle Timeout

Specify an idle time-out in the Max Idle Timeout field when you select Connect 

on Demand. The default setting is 0, which means the Internet session will not 

timeout.

NAT

NAT is the translation of the IP address of a host in a packet, for example, the 

source address of an outgoing packet, used within one network to a different IP 

address known within another network.

None

Select None to disable NAT.

SUA Only

SUA only is available only when you select Routing in the Mode field.
Select SUA Only if you have one public IP address and want to use NAT. Click 

Edit to go to the Port Forwarding screen to edit a server mapping set. 

Back

Click Back to return to the previous screen.

Apply

Click Apply to save the changes. 

Cancel

Click Cancel to begin configuring this screen afresh.

Advanced Setup

Click this button to display the More Connections Advanced screen and edit 

more details of your WAN setup.

Table 23   More Connections Edit (continued)