ZyXEL p-660hwp Manual Do Utilizador

Página de 402
Chapter 6 LAN Setup
P-660HWP-Dx User’s Guide
42
6.4  DHCP Setup
Use this screen to configure the DNS server information that the P-660HWP-Dx sends to the 
DHCP client devices on the LAN.
Figure 57   DHCP Setup
The following table describes the labels in this screen.
Active
Select the Active check box to enable the Any IP feature. This allows a computer 
to access the Internet without changing the network settings (such as IP address 
and subnet mask) of the computer, even when the IP addresses of the computer 
and the P-660HWP-Dx are not in the same subnet. 
When you disable the Any IP feature, only computers with dynamic IP addresses or 
static IP addresses in the same subnet as the P-660HWP-Dx’s LAN IP address can 
connect to the P-660HWP-Dx or access the Internet through the P-660HWP-Dx.
Windows 
Networking 
(NetBIOS over 
TCP/IP)
NetBIOS (Network Basic Input/Output System) are TCP or UDP packets that 
enable a computer to connect to and communicate with a LAN. For some dial-up 
services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls. 
However it may sometimes be necessary to allow NetBIOS packets to pass 
through to the WAN in order to find a computer on the WAN.
Allow between 
LAN and WAN
Select this check box to forward NetBIOS packets from the LAN to the WAN and 
from the WAN to the LAN. If your firewall is enabled with the default policy set to 
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall 
rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN 
and from the WAN to the LAN.
Back
Click Back to return to the previous screen.
Apply
Click Apply to save the changes. 
Cancel
Click Cancel to begin configuring this screen afresh.
Table 27   Advanced LAN Setup (continued)
LABEL
DESCRIPTION