ZyXEL p-662h-61 Guia Do Utilizador

Prestige 662HW Series User’s Guide

331

Chapter 31 Remote Node Configuration

The following figure uses sample IP addresses to help you understand the field of My WAN 
Addr in menu 11.3. Refer to the previous

in the web configurator chapter on LAN 

setup for a brief review of what a WAN IP is. My WAN Addr indicates the local Prestige 
WAN IP (172.16.0.1 in the following figure) while Rem IP Addr indicates the peer WAN IP 
(172.16.0.2 in the following figure).

Address 
Mapping Set

When Full Feature is selected in the NAT field, configure address mapping sets in 
menu 15.1.  Select one of the NAT server sets (2-10) in menu 15.2 (see

for details) and type that number here.

When SUA Only is selected in the NAT field, the SMT uses NAT server set 1 in menu 
15.2 (see

for details).

Metric

The metric represents the cost of transmission for routing purposes. IP routing uses 
hop count as the cost measurement, with a minimum of 1 for directly connected 
networks. Type a number that approximates the cost for this link. The number need 
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good 
number.

Private

This determines if the Prestige will include the route to this remote node in its RIP 
broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast. 
If No, the route to this remote node will be propagated to other hosts through RIP 
broadcasts.

RIP Direction

Press [SPACE BAR] and then [ENTER] to select the RIP Direction.  Options are 
Both, In Only, Out Only or None.

Version

Press [SPACE BAR] and then [ENTER] to select the RIP version.  Options are RIP-1, 
RIP-2B or RIP-2M.

Multicast

IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and None disables 
IGMP.

IP Policies

You can apply up to four IP Policy sets (from 12) by typing in their numbers separated 
by commas. Configure the filter sets in menu 25 first (see

) and then apply them here.

When you have completed this menu, press [ENTER] at the prompt “

Press ENTER to Confirm 

or ESC to Cancel:

”  to save your configuration, or press [ESC] at any time to cancel.

Table 116   Menu 11.3 Remote Node Network Layer Options (continued)